Tectite 1/2 in. Copper Push-to-Connect x 8 in. 90-Degree Stub-Out Elbow
Product Overview
The Tectite by Apollo 1/2 in. x 8 in Copper Pipe Push-To-Connect Stub-out Elbow is typically used during the rough-in phase. Once the fixture is ready to be installed, simply cut the end of the stub-out. Install the fitting or valve necessary to make the final connection to the fixture.
- Constructed of lead free dezincification resistant (DZR) brass and copper for superior reliability and strength
- Push-to-connect joints require no heat, solder, solvents or tools
- Push-to-connect design allows for a simple and fast installation of water heaters to any combination of copper, PEX, CPVC or PE-RT pipe
- Fittings can be rotated after being installed for ease of use in tight spaces
- Ideal for potable water and hydronic heating applications
- Quarter turn lever handle for simple flow control
- Meets UPC, IPC, and cUPC standard requirements and listed by IAPMO and listed to ASSE 1061/NSF 58
- Demount clip allows for valve removal (included)
- Approved for behind-the-wall with no access and burial
- Corrosion resistant for greater longevity
- Maximum working pressure of 200 psi and maximum temperature of 250 degree F
Proposition 65 Information
WARNING: This product contains chemicals known to the state of California to cause cancer and birth defects or other reproductive harm. Further information available at www.p65warnings.ca.gov.
Documentation
Specifications
Warranty
Lifetime: For exclusive use with:PEX - ASTM F876/CSA B137.5Copper - ASTM B 88 hard drawn copper tube K, L, & MCPVC - ASTM D2846 or CSA B137.6PE-RT - ASTM F2769